Treatment of water leakage of water tap
Article author：admin To update：2017-03-02
Taps are mainly used to control the size of the water outlet switch and water flow. In the early days of the screw is a screw type, and now most of the market is the core of the ceramic faucet, spiral lift has basically eliminated. In the usual life, sometimes found in tap water after tightening will drop, but also from the outlet of the tap or joint drop stop, not only caused a lot of waste, sometimes the noise would cause some trouble. How does the faucet leak do? How does faucet leakage handle?
In fact the tap structure is very simple, the maintenance is Water Leakage can repair it yourself, in general, Water Leakage problem as long as the change in the tap internal axial gasket or sealing gasket gasket triangular parts, can be solved. However, before the renovation of the home must be turned off the tap.
A tap joint of the Water Leakage Water Leakage will repair, the reason is nothing more than a faucet part (fixed screw) the damage caused by the sealing tape. Therefore, as long as the use of plate clamp will tap off, to roll on the new sealing tape can be fixed in the lo Ting place, for the maintenance of the following steps: first, the faucet fastened, with a wrench to turn the tap off the counter clockwise rotation. Second, the threaded hole outward, in the threaded part of the wind with the tape on the clock back 5-6.
See whether there is a good water tap to adjust the plate clamp clockwise direction of the clock, the final installation is completed, open the main switch to try to confirm whether there will be leakage. Even if the tap is fastened, will still cause the Water Leakage:
1 reasons: it is because Water Leakage outlet axial gasket due to wear and tear in the faucet. Using a pair of pliers and remove the gland to turn loose, to clamp the axis of gasket removed, replaced with new axial gasket.
2 leading to lower gap Water Leakage reasons: it is because the triangle gland gasket caused by wear. You can turn the screw loose off to head, then loosen the gland removed, then the gland inside the triangle seal shop removed, replaced with new.
3 joint Water Leakage: basically cover type nut loose, then you can re fasten cap nut or replace new U type gasket.
Tap water if there is less, is likely to occur Water Leakage situation, because the water faucet stuck disk single sand, this phenomenon is still looking for professional maintenance division leading dismantling cleaning, but if the pad damaged must be replaced. Generally speaking, the correct use of the tap, refers to the rotation of the leading is not too tight, all the leading rubber pad can be maintained for 7, 8 years of life, however, part of the hot water leading due to thermal expansion and contraction to reduce its life, it is generally recommended that the hot and cold pad on both sides of the best can also change regularly.